Seat Tarraco 2022 Owner's Manual page 163

Troubleshooting
✓ Valid for: hybrid vehicles
E-MODE operating mode is not availa-
ble
The indicator lamp lights up in white.
The E-MODE operating mode
electric mode) cannot be used temporarily be-
cause one or more conditions are not met.
●
The conditions must be met to use the E-
MODE operating mode.
Start-Stop system
Description and operation
Not valid for PHEV hybrid vehicles
The Start-Stop system helps you to save fuel
and reduce CO emissions.
2
In Start-Stop mode, the engine will automati-
cally switch off when the vehicle stops or is
stopping. The ignition remains switched on. The
engine automatically switches back on when
required.
In this scenario, the light of the
button remains lit.
1)
When the ignition is switched on, the Start-Stop
function is automatically activated.
1)
Only in vehicles with Keyless Access.
Start-Stop system
Control lamps
The Start-Stop system is available, the
automatic engine shutdown is active.
The Start-Stop system is not available or
has been disconnected.
Stopping and starting the engine
(driving in
Vehicles with a manual gearbox:
●
When the vehicle is stopped, put it into neu-
tral and release the clutch pedal. The engine
will stop. The warning lamp
the display. The engine may be stopped before
the vehicle comes to a standstill (approximately
7 km/h).
●
When you depress the clutch pedal, the en-
gine will start again. The indicator lamp goes
out.
Vehicles with an automatic gearbox:
●
Brake until the vehicle has come to a stand-
still, and keep your foot on the brake pedal or
activate the Auto Hold system so that the vehi-
cle remains braked. The engine will stop. The
warning lamp
The engine may stop before the car stops com-
pletely (approximately 7 or 2 km/h depending
on the vehicle's gearbox).
●
When you take your foot off the brake pedal
the engine will start up again. The indicator
lamp goes out. With the Auto Hold system, the
Driving
will light up on
will appear on the display.
engine will not start if you remove your foot
from the brake pedal. The car starts when you
press the accelerator pedal.
Basic requirements for the start/stop mode
●
The driver door must be closed.
●
The driver's seat belt must be fastened.
●
The bonnet must be closed.
●
The engine has reached operating tempera-
ture.
●
The reverse gear must not be engaged.
●
The vehicle must not be on a very steep
slope.
The engine does not turn off for various rea-
sons
Before stopping the vehicle, the system verifies
whether certain conditions are met. The engine
does not switch off, in the following situations
for example:
●
The engine has not yet reached the required
temperature for the Start-Stop mode.
●
The temperature selected on the climate
control has not been reached.
●
The interior temperature is very high/low.
●
De-icing function button activated.
●
Park assist is switched on.
●
The battery is very low.
161