Seat Tarraco 2022 Owner's Manual page 83

Fig. 62 On the charging cable for power
sockets: Indicator lamps on the protection
device.
›››
Fig. 62:
Indicator lamp of the connector and the
1
power supply.
Control lamp of the protection device
2
Control lamp of the vehicle
3
Failure warning lamp
4
Charging cable information
Before using the charging cable, also follow the
instructions displayed on it and on the rear of
the protective device.
Protection device
The electronic protection device
sures that the charging connector does not re-
ceive current until it is plugged in to the vehi-
cle's charging connector.
High-voltage battery
Self-check
When the charging cable is plugged into
the electrical socket, the protective device au-
tomatically performs a self-test. During this
check, all warning and indicator lamps turn on
briefly and go out one after the other. Upon
completion, the operational status at that time
is displayed.
Operating displays
One or more control lamps
light up green.
3
›››
Display Fig. 62
ignition
1
, on,
1 2
flashes slowly
3
›››
page 81
and
1 2 3
Set the charging current
The charging cable limits the charging current
according to the available power supply.
If the local mains supply does not allow charg-
›››
Fig. 62 en-
ing at the maximum charging current, the
charging current can be reduced, depending
on the charging setting features in the infotain-
›››
ment system
Charging cable
›››
Fig. 62 , or
1 2
Meaning
The charging cable is
plugged into the mains
The high-voltage battery
is charging.
on The charging process is
complete. The high-volt-
age battery has charged.
page 78.
Temperature control
The charging cable temperature control
switches on when the charging cable over-
heats, such as when it has been stored in a lug-
gage compartment exposed to high tempera-
tures or strong sunlight.
›››
Display Fig. 62 Meaning
, flashing The housing connector
1 4
has overheated.
, flashing The protection device has
2 4
overheated.
If the charging process continues with a lower
current, both the operating indicator and the
›››
warning lamp Fig. 62 flash red.
4
●
Unplug the charging cable from the mains
and wait for it to cool down.
●
If it disconnects again, or the charging cur-
rent reduces and the cause does not seem to
be exposure to an external heat source, make
sure that the green control lamp is flashing
›››
Fig. 62. To check the charging cable, please
visit a SEAT dealer. Get an establishment that
specialises in electrical installations to check
the infrastructure connection.
Fault display
If the red warning light flashes or turns on
4
without one of the indicator lamps
, or also turning on continuously on the
1 2 3
status indicator, there is a fault.
›››
Fig. 62
81