Seat Tarraco 2022 Owner's Manual page 26

Changing memory
●
While in Driving data > General in-
formation press on the multi-function
steering wheel to switch between the 3 memo-
ries :
1)
– Since start: The memory is deleted if
the journey is interrupted for more than 2
hours.
– Since refuel: Display and storage of
the journey data and the consumption val-
ues collected. When refuelling, the memory
is deleted.
– Long-term: This memory contains travel
data up to a maximum of 19 hours and
59 minutes or 99 hours and 59 minutes, or
up to a maximum of 1999.9 km or 9999.9
km. When one of these values is exceeded
(varies depending on the version of the in-
strument panel), the memory is deleted.
Delete journey data presets
●
Select the memory that you wish to erase.
●
Keep the button on the multi-function
steering wheel pressed for approximately 2
seconds.
1)
This will show all data on the display at the same time: distance travelled, average consumption, average speed and autonomy.
2) Valid for the SEAT Digital Cockpit.
3)
Not available in all countries.
24
Driver information
Select the instructions
In the Infotainment system, in the menu Vehicle
settings, you can display different travel data
›››
page 37.
– Current consumption: The current fuel
consumption display operates throughout
the journey, in litres/100 km; and with the
engine running and the vehicle stopped, in
litres/hour.
– Average consumption: The average
fuel consumption is displayed after driving
for approximately 300 metres.
– Travelling time: This indicates the
hours (h) and minutes (min) since the igni-
tion was switched on.
–
2) Approximate distance in km that
Range:
can still be travelled if the same driving
style is maintained.
– : Approximate dis-
AdBlue range or
tance in km that can still be travelled with
the current level of the AdBlue® tank with
the same driving style. The indication ap-
pears from a range of less than 2400 km
and cannot be deactivated.
– Distance travelled: Distance covered
in km (m) after switching on the ignition.
– Average speed: The average speed will
be shown after driving for approximately
100 metres.
– Digital speed: Current speed dis-
played in digital format.
– Eco tips: Recommendations messages
are shown to reduce consumption through
good driving practices, e.g. Air condi-
tioning on: close the window.
– Boost/Torque: Indicates the power and
torque of the combustion engine (does not
indicate electric mode).
Setting a speed warning
●
Select the display Warning at --- km/h or
Warning at --- mph.
●
Press the
steering wheel to memorise the current speed
and activate the warning.
●
Activate: set the desired speed within 5 sec-
onds by rotating the wheel on the multi-func-
tion steering wheel. Next, press the
again or wait for a few seconds. The speed is
3)
stored and the warning activated.
●
Deactivate: press the
speed is deleted. The warning can be set for
speeds of between 30 and 250 km/h (18 and
155 mph).
button on the multi-function
button
button. The stored