Seat Tarraco 2022 Owner's Manual page 215

What happens in the event of automatic
braking?
If there is an obstacle, the system brakes the
vehicle to a standstill and keeps it stationary for
approx. 2 seconds. Press the brake!
Activate
●
Automatic braking is activated when the
driver switches a parking system on.
Deactivating
●
The automatic brake operation function de-
activates when a park assist system is switched
off.
●
OR: to temporarily deactivate the manoeuvre
braking function, press the function button
on the park assist screen and change the set-
ting.
WARNING
Never allow the automatic braking opera-
tions of park assist systems to lead you to
take any risk that compromises safety. In
certain situations, the automatic braking in-
tervention may only work in a limited way
or not work at all. Collisions with obstacles
can injure people and damage the vehicle.
The system is not a replacement for driver
awareness.
General information on parking systems Parking and manoeuvring
●
Pay attention and do not rely solely on
park assist systems.
●
Always be prepared to brake and control
the steering yourself.
●
Do not take any risks that compromise
safety.
●
Act in accordance with the warnings and
driving recommendations of the parking sys-
tems.
Note
● Switch off the parking system if the auto-
matic brakes operate excessively, e.g. when
driving off-road.
● After the park assist's manoeuvre braking
function has braked the vehicle, driving in the
same direction for 5 metres is deactivated,
and becomes active again after changing
gear or changing the position of the gear se-
lector.
Troubleshooting
The parking system behaves differently than
expected
There can be several causes:
●
The system requirements are not met.
●
The sensors or the camera are dirty or have
›››
ice on them page 371.
●
The camera lens is not clean and the camera
›››
image is not clear page 371.
●
Some noise sources, such as a jackhammer
or a cobblestone surface can interfere with the
ultrasound signal.
●
The vehicle has some type of damage in the
sensor or camera area, e.g. due to a parking
impact.
●
The sensor detection zone or field of view of
the camera are blocked by an accessory, e.g. a
bike rack.
●
Changes have been made to the paintwork
or structural modifications in the sensor or
camera area, e.g. at the front of the vehicle or
to the running gear.
Also take into account the messages displayed
on the infotainment system screen.
Sensor or camera without visibility, or the
parking system has been switched off
If a sensor fails, that sensor zone is permanently
switched off. The affected sensor zone may be
displayed on the infotainment system with a
symbol and a greyed-out graphic segment. If
necessary, the parking system switches off the
affected zone.
If the park assist is not working properly, a con-
tinuous audio signal sounds for a few seconds
when it is switched on. If applicable, a message
to this effect is displayed on the instrument
cluster screen
213