Seat Tarraco 2022 Owner's Manual page 236

●
There is a non-articulated one or two axle
trailer hitched and electrically connected.
●
Both the tow vehicle and trailer are stopped.
●
The maximum bending angle has not been
exceeded.
●
The length of the trailer's drawbar has been
determined.
Determine the length of the trailer's drawbar
In order for the trailer manoeuvre assistant
to determine the length of the trailer's draw-
bar, drive the vehicle-trailer set through some
turning manoeuvres or curves. The more pre-
cisely the length of the drawbar is determined,
the wider the angles that will be available
when manoeuvring. The assistant subdivides
the maximum available end stops of the angle
indicator into four levels: approx. 30°, 45°, 60°
and 75°.
Note
For technical reasons, the trailer manoeu-
vre assistant cannot always correctly detect
trailers with LED technology taillights.
234
Parking and manoeuvring
Operating
Fig. 172 Outside rearview mirror rotary control:
adjust the trailer angle.
Fig. 173 Instrument cluster display: engage
reverse.
››› ›››
Key to the Fig. 172 , Fig. 173:
Rotary exterior mirror controls.
1
Trailer orientation to the left
2
Trailer orientation to the right
3
Move the vehicle in the direction of the tow-
4
ing device.
Actual trailer position
5
Target trailer position
6
Angle indicator zero position
7
Manoeuvre with the tow vehicle and trailer
set
The system requirements must be met
›››
page 233.
●
Select reverse gear.
●
Press the button.
›››
●
Let go of the steering wheel
●
Tilt the rotary control until the desired direc-
›››
tion is reached Fig. 172. A representation of
the tow vehicle and trailer set is shown on the
instrument cluster screen for guidance purpo-
›››
ses Fig. 173.
●
Reverse by accelerating slowly. Pay attention
to your surroundings!
●
If necessary, correct the angle with the rotary
control. Press the control towards the left or
right: the set will move to the left or right. Press
the control backwards: the vehicle will follow
the trailer.
●
Reverse and move forwards until the desired
position is reached.
●
The manoeuvre ends when a message is dis-
played on the instrument cluster display and, in
some cases, an audio signal sounds.
.