Seat Tarraco 2022 Owner's Manual page 213

WARNING
If the vehicle is left improperly, it could roll
away. This could lead to accidents, serious
injury and property damage.
●
When parking the vehicle, always perform
the appropriate operations in the indicated
›››
page 209, Parking
order .
●
Before leaving the vehicle, make sure that
the electronic parking brake is applied and
that the control lamp next to the gear se-
lector is red on the instrument cluster.
WARNING
The improper use of the electronic parking
brake can cause accidents and serious in-
jury.
●
Never use the electronic parking brake to
stop the vehicle, unless it is an emergency.
The braking distance is considerably longer.
Always use the brake pedal.
●
Never accelerate from the engine when a
gear range or a gear is engaged and the en-
gine is running. The vehicle could move, even
if the electronic parking brake is activated.
NOTICE
To prevent the vehicle from unintentionally
moving when parking it, first apply the elec-
tronic parking brake and then remove your
foot from the brake pedal.
Parking and manoeuvring Electronic parking brake
Troubleshooting
The electronic parking brake does not re-
lease.
The 12-volt battery is discharged.
›››
●
Use the jump start page 320.
The electronic parking brake makes noises
●
When the electronic parking brake is applied
and released, noises may be heard.
●
The system performs automatic and audible
checks sporadically in the parked vehicle if
some time elapses without the electronic park-
ing brake being used.
Auto-Hold function
Fig. 155 In the lower part of the centre
console: Auto Hold function button.
The Auto-Hold function holds the vehicle at a
standstill and prevents it from moving without
it being necessary to keep the brake pedal de-
pressed.
When the Auto-Hold function is active, the
control lamp on the instrument cluster
lights up green. The control light of the
›››
Fig. 155 button remains on when the
Auto Hold function is connected.
Requirements
●
The driver's door is closed.
●
The driver's seatbelt is buckled.
●
The engine is running.
Connecting and disconnecting
›››
Press the Auto Hold button
lamp on the button turns on when the Auto Hold
function is switched on. The function is now
available to be activated. The control lamp on
the button goes out when the Auto Hold func-
tion is switched off.
Switching on and off automatically
If the Auto Hold function was switched on via
the Auto Hold button before switching the igni-
tion off, the function will remain on the following
time the ignition is switched on.
If the Auto Hold function was not switched on, it
will remain off next time the ignition is switched
on.
. The control
211