Table of Contents
Advertisement
GRASS CATCHER
1.
To fit: Raise the rear cover and hitch the grass catcher onto the holder on rear of mower
(fig. 18).
2.
To remove: grasp and lift rear cover. Lift the grass catcher out of the holder and backwards
to remove it.
•
When emptying the basket, clean it so that it's permeable to air.
•
Emptying catcher before filling the maximum (at 50-70% content) will improve the collection
of grass.
CHASSIS
The bottom of the cover and the discharge tunnel must be cleaned after each use. The accumulation
of grass deposits, leaves and muddy deposits, etc. cause corrosion and can prevent the engine
from running properly. When cleaning the underside of the cover, tilt the mower so that
the spark plug is facing in an upward direction.
HEIGHT ADJUSTMENT INSTRUCTIONS
A
CAUTION!
Do not at any time make any adjustment to lawnmower without first stopping
the engine and disconnecting the spark plug wire.
The mower can be adjusted by changing the position of wheels on three height.
1.
Remove the wheel covers.
2.
Use a wrench to unscrew the wheels.
3.
Screw back the wheels in the desired position (fig. 6). Between the wheel and the body of
the mower must be placed a small pad (fig. 7-8). All wheels must be set to the same height.
I
When assembling, ensure the correct placement of the bolts (LH = left, RH = right).
Note:
I
RH = Clockwise rotation / LH = Counterclockwise rotation.
Note:
A
CAUTION!
Tighten the wheels securely.
4.
Put wheel cover.
FOR THE BEST RESULTS MOWING
C Your mower is designed to cut normal residential grass of a height no more than
250 mm.
•
Clear lawn of debris. Be sure that the lawn is clear of stones, sticks, wire or other foreign
objects which could be accidentally thrown out by the mower or wrapped around
the rotating parts. It may cause serious personal injury to the operator and others as well as
damage to property and surrounding objects.
EN
DE
CS
SK
PL
HU
29 / 48
Advertisement
Table of Contents
