Drive Control; Mowing; Grass Catcher; Chassis - hecht 5433 SW Translation Of Original Instructions For Use

Table of Contents

Advertisement

Available languages

Available languages

1.
Release the brake control handle to stop the engine and blade.
2.
Turn the fuel valve - if equipped - to "OFF" position.
3.
Disconnect and ground the spark plug wire, to prevent accidental starting while equipment
is unattended.

DRIVE CONTROL

1.
Grip the Self-drive control handle (
(ground speed - see Specifications).
2.
Release the Self-drive control handle until the lawn mower doesn't go forward.
A
CAUTION!
Do not manipulate the Self-drive control handle if the engine is not running. It may
damage the drive system!

MOWING

B
WARNING!
Before performing any of the steps described in the following steps, always stop
the engine and wait for the blade to stop rotating. In a case where it's necessary to
reach into the work area of the stopped blade, it's necessary to secure the engine
against accidental starting (e.g. by pulling the cable end of the spark plug).
THIS WARNING WON'T BE REPEATED IN THE FOLLOWING STEPS.

GRASS CATCHER

1.
To fit: Raise the rear cover and hitch the grass catcher onto the holder on rear of mower
(
. 20).
fig
2.
To remove: grasp and lift rear cover. Lift the grass catcher out of the holder and backwards
to remove it.
There is a value on the collection basket flap to indicate that the basket is full (
When the engine is running, air is thrown into the basket which opens the flap. If the flap
is already closed, the basket must be emptied. When emptying the basket, clean it so that
it's permeable to air.
Emptying catcher before filling the maximum (at 50-70% content) will improve the collection
of grass.
C IMPORTANT! If the indicating flap is dirty, it won't work properly. Make sure
the flap is kept clean.

CHASSIS

The bottom of the cover and the discharge tunnel must be cleaned after each use. The accumulation
of grass deposits, leaves and muddy deposits, etc. cause corrosion and can prevent the engine
from running properly. When cleaning the underside of the cover, tilt the mower so that
the spark plug is facing in an upward direction.
. 19A), the lawnmower will move forward automatically
fig
EN
DE
CS
SK
PL
HU
. 21).
fig
33 / 56

Advertisement

Table of Contents
loading

Table of Contents