Table of Contents
Advertisement
EN
Engine difficult
to start or loses
power.
Engine operates
DE
erratically.
Engine idles poorly.
CS
Engine skips at
higher speeds.
Engine overheats
SK
Mower vibrates
abnormally
A
CAUTION!
PL
Faults which can not be rectified with the aid of this table may be rectified by
a authorized service centre.
SERVICE AND SPARE PARTS
HU
•
Have your device serviced by a qualified repair personnel using only identical replacement
parts. This will ensure that the safety of the device is maintained.
•
Whether you need technical advice, repair, or genuine factory replacement parts,
contact the HECHT authorized service nearest you. Information on service locations, visit
www.hecht.cz
•
When ordering spare parts, please quote the part number, this can be found at
www.hecht.cz
DISPOSAL
•
Dispose your device, accessories and packaging in accordance with the requirements of
environmental protection into the recycling collection center.
•
This machine does not belong to the household waste. Save the environment and take this
device to designated collection points where it will be received for free. For more information
please contact your local authority or nearest collection point. Improper disposal may be
punished according to national regulations.
40 / 48
Dirt, water, or stale fuel tank.
Vent hole in fuel tank cap is
plugged
Air filter element is clogged.
Spark plug is defective.
Spark plug gap is incorrect.
Air filter element is clogged.
Air filter element is clogged.
Air slots in engine shroud are
clogged.
Cooling fins and air passages
under engine blower housing are
clogged.
Gap between electrodes of spark
plug is too close.
Cooling air flow is clogged.
Incorrect spark plug.
Cutting assembly is loose.
Cutting assembly is unbalanced
Drain fuel and clean tank. Fill tank with clean, fresh
fuel
Clean or replace fuel tank cap.
Clean air filter element.
Install new, correctly gapped plug
Set the correct gap between the electrodes - see
Specifications
Clean air filter element
Clean air filter element
Remove debris from slots.
Remove debris from cooling fins and air passages.
Set the correct gap between the electrodes - see
Specifications
Remove any debris from slots in shroud, blower
housing, all air passages
Install original spark plug.
Tighten blade
Balance blade.
Advertisement
Table of Contents
