Nortel Meridian Meridian 1 Implementation Manual page 64

Page 64 of 208
Procedure 6
Access the MICB remotely using a modem
1
2
3
4
5
6
Procedure 7
Access the MICB remotely using a LAN hub
1
2
3
4
Note: For local testing purposes, or direct connection from the Ethernet port to a PC, use
an Ethernet cross-over cable purchased at a local computer store.
If installing the MICB card in a Succession 1000, Succession 1000M
Cabinet, or Meridian 1 Option 11C Cabinet, use the following
procedures to connect the Maintenance terminal.
Note: These procedures do not apply to the Large Systems or
Meridian SL-100.
In the procedures that follow, the connections are the same for the
Succession 1000, Succession 1000M Cabinet, and Meridian 1
Option 11C Cabinet.The only difference is that the connectors are on
the back of the Succession Call Server and Succession Media Gateway
for the Succession 1000, whereas they are on the bottom of the
Succession 1000M Cabinet and Meridian 1 Option 11C Cabinet.
553-3001-358 Standard 1.00
Verify that the Ethernet Adapter card is on the I/O panel as described in
Procedure 4 on page 62.
Plug the terminal cable DB-9 female connector into the DB-9 male connector
on the Ethernet Adapter card on the I/O panel.
Plug the DB-25 male connector at the other end of the terminal cable into the
DB-25 female connector of a DB-25F/DB-25M nullmodem adapter. If a
female-to-female nullmodem is required, use a customer-supplied
nullmodem.
Plug the DB-25 male connector of the nullmodem adapter DB-25F/DB-25M
into the DB-25 female connector on the modem. If a female-to-female
nullmodem is required, use a customer-supplied nullmodem.
Plug the modular modem cable RJ11 plug into the RJ11 jack on the modem.
Plug the other end of the modular modem cable RJ11 plug into the RJ11 jack
on the wall.
This procedure is now complete
Verify that the Ethernet Adapter card is on the I/O panel as described in
Procedure 4 on page 62.
Plug the modular cable RJ-45 plug into the RJ-45 jack on the NT5D52AC
Ethernet Adapter card.
Plug the RJ-45 plug at the other end of the modular cable into the Ethernet
LAN hub.
Make the remaining Ethernet connections as required using standard
Ethernet connection rules.
This procedure is now complete
October 2003