Nortel Meridian Meridian 1 Implementation Manual page 150

Page 150 of 208
Table 40
Modifying objects
Command
<cr>
value <cr>
.
To modify a value or attribute of an object, the program responds with
a sequence of prompts: one prompt for each attribute of the object. The
prompt defines the name and the current value of the attribute. You can
change the value, accept the current value, or cancel the modification
as follows:
The system can display the current value and a list of available values
to select. In the following example, the value of attribute_d changes to
bbbb:
When executing the command(s), the program provides the option to
modify, save, or cancel the changes. When Save is entered, the system
accepts the changes. After the session ends, use the commands in
Table 38 on page 149
553-3001-358 Standard 1.00
Result
Accepts the current value when the Enter key is pressed.
Changes the attribute with a new value when the value is entered and the Enter
key is pressed.
Cancels the modification and allows the object to keep its previous value.
attribute_a (current_value_a): new_value_a <cr>
attribute_b (current_value_b): <cr>
attribute_c (current_value_c): .
attribute_d (current_d, (1-aaaa, 2-bbbb, 3-cccc)): 2
October 2003
to navigate through the menus.