Nortel Meridian Meridian 1 Implementation Manual page 192

Page 192 of 208
Procedure 36
Stand-alone card to primary card
1
2
3
4
5
6
Procedure 37
Switch configuration changes
1
2
553-3001-358 Standard 1.00
Access the MICB Installation Wizard: Step 1 – Basic Card Settings window
(see "Step 1 – Basic Card Settings" on page
radio button "Dual Card – Primary."
Click the Submit & Continue button.
If 10 DN pairs are configured, the system deletes one automatically. The
MICB first attempts to delete a DN pair that has no conferences scheduled
against it. If no such DN pair is found, the MICB deletes the DN pair with the
least number of conferences using it. All associated conferences are deleted.
Note: A DN pair used by a permanent conference is not deleted.
If a DN pair is deleted in direct-access dialing mode, a pop-up message
appears. Note the deleted DN pair, as it can be removed from the switch
configuration.
The system displays Step 2 of the Installation Wizard (see
Numbers" on page 72). If the automatic change, as described above, took
place, this is reflected in the DN table. If the direct access dialing mode is
used, only nine DNs appear.
Click the Submit & Continue button.
The system displays Step 4 of the Installation Wizard (see
Card Meetings" on page 73
If a DN pair was automatically deleted as described above, it appears in the
fields "Conference access number" and "Chairperson number in primary
card." You can change these numbers; they must be configured in the switch
as well.
Fill in all the fields as described in the installation instructions, and click the
Finish button.
Logout of this card and proceed with the switch configuration change (see
).
Procedure 37
This procedure is now complete
If a DN pair was deleted from the secondary or primary card, delete it from
the switch datafill.
Configure the DNs defined in the Installation Wizard Step 4 window of the
primary MICB. Define them as described in the dual-card MICB installation
instructions (for the Succession 1000M, Succession 1000, and Meridian 1,
see "Configure DNs for a dual-card conference" on page
SL-100, see "Dual-card configuration" on page 56
This procedure is now complete
October 2003
69). In the "Type" field, select the
).
"Step 2 – Access
"Step 4 – Dual
48; for the Meridian
).