Installation And Configuration; Purpose; Getting Started - Nortel Meridian Meridian 1 Implementation Manual

Installation and configuration

Purpose

This chapter describes how to:
• prepare the system for MICB installation
• install the MICB into the IPE module (Succession 1000M Cabinet or
Meridian 1 Option 11C Cabinet shelf, or Succession Media
Gateway slot in the Succession 1000)
• connect the MICB to the administration terminal
• configure the card
The chapter contains the following sections:
• "Getting started" on page 41
preparing for an installation.
• "Succession 1000M, Succession 1000, and Meridian 1
configuration" on page 42
Succession 1000M, Succession 1000, and Meridian 1.
• "Meridian SL-100 configuration" on page 51
configure the Meridian SL-100.
• "MICB installation and configuration procedures" on page 61
shows how to install the card and set up the web server.
• "MICB Installation Wizard" on page 68
the BUI's Install Wiz to complete configuration.

Getting started

To begin the installation, unpack and inspect the components, take
inventory, and determine the IPE card slot(s) in which to install the
MICB card(s). See Table 2 on page 21 for a complete listing of the
MICB hardware.
Unpack and inspect the equipment
Unpack and inspect the equipment for damage. Follow the steps in
Procedure 1 on page 42
configuration procedures in this chapter.
Meridian Integrated Conference Bridge
– describes the steps to use when
– shows how to configure the
before performing the installation and
Service Implementation Guide
Page 41 of 208
– shows how to
– describes how to use
–