Meridian Sl-100 Configuration - Nortel Meridian Meridian 1 Implementation Manual

Note: Because of the number and variety of DNs programmed for
the dual-card setup, Nortel Networks recommends creating a dialing
plan chart similar to
configuring the primary and secondary card attributes, including the
dual-card settings, in the administration BUI.
Finally, configure each port on the primary and secondary cards as a
digital set. See

Meridian SL-100 configuration

Single-card configuration
After installing the MICB card(s) and connecting the terminal for CLI
access and the server for BUI access, perform Meridian SL-100
database configuration. Figure 11 shows the tables to datafill for
single-card setup.
Note: If single-number access is being used, the DN pairs are not
required. Instead configure a single-number access DN.
Figure 11
Single-card conference, 10 conferences, 32 ports
MICB
997-1400 (Main ACD DN to route to ACD agents)
997-1601 to 997-1610 (setup for up to 10 MICB conferences)
997-1701 to 997-1910 (setup for up to 10 MICB chairpersons)
997-1800 (setup for single access MICB conference call)
997-1900 (setup for single access MICB conference call)
Meridian Integrated Conference Bridge
Table 8 on page
Table DNROUTE
MICB
997-1400
Table OFRT
601 997-1400
Table DNROUTE
Table 10 on page 50. Refer to this chart when
45.
32 ACD
agents
assigned to
MICB
ACDGRP
Service Implementation Guide
Page 51 of 208
MICB Card
G100016