Powering Up The Remote Gateway 9110 Circuit Card - Nortel Remote Gateway 9110 Installation And Administration Manual

June 2005
Complete the following procedure:
1 If you want to route calls over the IP network or administer the Remote
Gateway 9110 circuit card with Configuration Manager, connect the circuit
card to the Ethernet network by making the following connections:
a. Connect one end of the RJ-45 Ethernet cable to the ETHERNET
b. Connect the other end to either an Ethernet hub or network router.
2 Connect the Remote Gateway 9110 circuit card to the power source as
follows:
a. Connect the appropriate cord on the power transformer to the power
b. Plug the power connector into an uninterruptible power supply (UPS) or

Powering up the Remote Gateway 9110 circuit card

As soon as you connect the Remote Gateway 9110 circuit card to the power
source, the circuit card begins to power up.
During power-up, the Remote Gateway 9110 circuit card performs a self-test.
The power LED flashes three times to verify all critical functionality.
If the Remote Gateway 9110 circuit card completes a successful self-test, the
telephone display shows one of the following messages:
A time and date, if connected to a PBX.
HOSTLESS MODE, if not connected to a PBX.
Note: The ETHERNET TX and RX LEDs flash only in response to transmit and
receive activity.
Remote Gateway 911x Series Installation and Administration Guide
connector on the Remote Gateway 9110 circuit card.
connector on the Remote Gateway 9110 circuit card.
wall outlet.
Installing the Remote Gateway 911x series unit
63