Testing The Network Connection - Nortel Remote Gateway 9110 Installation And Administration Manual

Installing the Remote Gateway 911x series unit

Testing the network connection

After you have installed the hardware and performed initial configuration, use
the following methods to test the network connectivity:
Perform a PING test.To perform this test, the following must be true:
— You must be physically connected to the network.
— You must be logged on to Configuration Manager.
Refer to "Using Configuration Manager's PING" on page 225 for com-
plete details on performing a Configuration Manager PING.
Perform a PSTN connectivity test. Refer to the Reach Line Card
Installation and Administration Guide (NTP 555-8421-210) for complete
details.
Perform a syslog test.
Refer to "Syslog testing" on page 228 for complete details on performing a
syslog test.
70 Remote Gateway 911x Series Installation and Administration Guide
Standard 3.0