Table of Contents
Advertisement
Installation, Operation, Maintenance Manual
20
Appendix - Installing ES Board Software
20.1
Media Gateway 3500 Media Gateway Version 2.1
Media Gateway 3500 Media Gateway version 2.1 does not support automatic
management of the Ethernet Switch board's software. Therefore, the user must
perform the installation manually as described below.
Software on Ethernet Switch boards os to be installed in the following cases:
Initial system installation
Ethernet Switch Board replacement
Rollback after Online Software Upgrade
1.
Make sure that the uplink is connected to port 25 (optical 1Gb port).
2.
Transfer the pti.4411.mode4.tar installation package to the Active SC board via FTP.
3.
Connect to the Active SC board via Telnet or RS232 console.
4.
Open the pti.4411.mode4.tar installation package.
client18::~# tar xvf pti.4411.mode4.tar
5.
Change the directory to the pti.4411.mode4 and run installation script.
client18::~# cd pti.4411.mode4
client18::/pti.4411.mode4# ./install
6.
Enter the IP address of the Ethernet Switch Board when prompted.
client241::/pti.4411.mode4# ./install
=========================================
Update software on Ethernet Switch Boards
=========================================
Enter Ethernet Switch Board's IP address : 10.1.1.35
Enter Ethernet Switch Board's subnet mask : 255.255.0.0
Verify IP address... done
Upload software to Ethernet Switch Board... done
New software was successfully uploaded to the Ethernet
Version 3.0
To install software on an Ethernet Switch Board, take
these 8 steps:
(v2.1,
Mode 4)
20. Appendix - Installing ES Board Software
211
October 2005
Advertisement
Table of Contents
Troubleshooting
