Nortel Remote Gateway 9110 Installation And Administration Manual page 116

Configuring the 911x unit using the telephone menu
IF you want to
enable IP
connection to the
RLC from this
Remote Gateway
911x series unit,
disable IP
connection to the
RLC from this
Remote Gateway
911x series unit,
92
THEN do the following:
1 Press 1.
2 Press the Hold key.
Result: The telephone display prompts you to enter
an IP address for the RLC and shows the current
value it has for this address, similar to the following:
Enter RLC IP Address
192.68.243.254
3 Press the digits of the new RLC IP address.
4 Press the Hold key.
Result: The telephone display prompts you for the
IP Signaling setting for this Remote Gateway 911x
series unit and displays the current setting, similar to
the following:
IP Signaling
1-Permanent 2-OnDemand:2
5 Choose from the options presented.
6 Press the Hold key.
7 Proceed to step 14, below.
1 Press 2.
2 Press the Hold key.
Result: The telephone display asks if you want to
enable PSTN calling to this Remote Gateway 911x
series unit, similar to the following:
Enable PSTN to RLC?
[1-Yes 2-No]
Remote Gateway 911x Series Installation and Administration Guide
Standard 3.0