Going Online And Offline; Using The Spre Code To Place Your Unit In Online Mode; Using The Spre Code To Place Your Unit In Offline Mode - Nortel Remote Gateway 9110 Installation And Administration Manual

June 2005

Going online and offline

Your Remote Gateway 911x series unit site can operate in either online mode or
offline mode. This is controlled by one or both of the following:
SPRE codes to manually toggle between online and offline modes.
An online/offline schedule on the host PBX to automatically toggle your
site between online and offline modes.
For a description of the online and offline modes, refer to "Modes of operation"
on page 136.

Using the SPRE code to place your unit in online mode

To use the SPRE code to place your unit in online mode:
1 Lift the telephone handset, or press the local calling key.
2 Press the pound (#) key followed by the online SPRE code.
Note: Contact your system administrator for the online SPRE code.
Result: The connection to the host PBX is initiated and negotiated with the
host PBX. During this negotiation period (up to five seconds), you cannot
place host-controlled calls. When negotiation is completed and connection
to the host PBX has been established, Online Mode appears on the
telephone display and the system is ready to place and receive host calls.

Using the SPRE code to place your unit in offline mode

To use the SPRE code to place your unit in offline mode, dial the pound (#) key
followed by the offline SPRE code.
Note: Contact your system administrator for the online SPRE code.
Result: Offline Mode appears on the telephone display.
Remote Gateway 911x Series Installation and Administration Guide
Using the digital telephone
151