Nortel Remote Gateway 9110 Installation And Administration Manual page 84

Installing the Remote Gateway 911x series unit
3 Use both hands to push forward until the circuit card snaps into place under
the brackets.
Note: Two holes on either side of the circuit card are now aligned with the
corresponding holes on the footstand.
4 Attach the Remote Gateway 9110 circuit card to the footstand with the
screws supplied in the Installation Kit.
Note: Refer to "D" in the diagram on page 60.
5 Plug the male RJ-11 connector on the loose end of the Meridian Line Cord
attached to the Remote Gateway 9110 circuit card into the jack on the
telephone.
6 Re-attach the footstand to the bottom of the telephone.
7 Apply the overlay identifying the power connection, the jack for an analog
line connection for PSTN functionality, and the jack connecting your
Ethernet for IP network connectivity.
60
C
9110 card
D
Remote Gateway 911x Series Installation and Administration Guide
Standard 3.0
G101493