Page 2
Standard 1.1 All rights reserved. The information in this document is subject to change without notice. The statements, configurations, technical data, and recommendations in this document are believed to be accurate and reliable, but are presented without express or implied warranty. Users must take full responsibility for their applications of any product specified in this document.
Page 3
Standard 1.1 Congratulations on your purchase of the Remote Gateway 911x series unit. With the Remote Gateway 911x product you have the advantage of a full featured host PBX at your home office. This Quick Start Guide gets you up and running with your Remote Gateway unit.
Page 5
Standard 1.1 You need a 10BaseT Ethernet cable to provide the Remote Gateway 911x series unit with voice over IP capability. For instructions on how to install a Remote Gateway 911x unit turn to You need the following tools to install the Remote Gateway 9110 circuit card in your Meridian (M2000 series) digital telephone: •...
Page 6
Standard 1.1 Secure the circuit card to the footstand with the two screws provided. Plug the 18 cm (7 inch), TCM cable into the RJ11 jack on the telephone (the other end is attached to the Remote Gateway 9110 circuit card). Re-attach the footstand to the bottom of the telephone (2 screws).
Page 7
Remote Gateway 911x Series Installation and Administration Guide (555-8421-220). To route calls over the IP network, or administer the Remote Gateway 911x series unit from another location on the IP network, connect the unit to the Ethernet...
Page 8
Standard 1.1 To connect the Remote Gateway 911x series unit to the power source as follows: Connect the plug on the power transformer to the POWER connector on the Remote Gateway 911x series unit. Attach the power cord to the power transformer.
Page 9
Standard 1.1 You can configure the Remote Gateway 911x series unit through the telephone set. The procedure is the same for either the Remote Gateway 9110 circuit card or 9115 unit. Before you begin, your System Administrator must supply you with a completed Remote Gateway 911x series telephone menu —...
Page 10
Release (Rls, R, or Goodbye depending on your telephone set) key once. After installing the Remote Gateway 911x series unit and powering up: Press the Release key four times within three seconds to access the telephone menu.