Advertisement
15.
Use (A) and (D) to change the end time
minute setting.
Minutes
16.
Press (C) to complete the setting
operation.
After the setting operation is complete, a
check mark appears for a few seconds,
and then the night time setting screen re-
appears.
17.
Hold down (E) for at least one second to
return to the current time screen.
Note
The allowable night time setting range
●
is no shorter than six hours and no
longer than 12 hours. If you configure
a setting outside this range, the end
time is automatically corrected, so the
setting is within the allowable range.
If you do not perform any operation for
●
two or three minutes while the setting
screen is displayed, the watch
automatically returns to the current
time screen.
If sleep measurement is performed
●
while [ACTIVITY & NIGHT TIME ON] is
selected for heart rate measurement,
sleep measurement will start from the
time set for NIGHT TIME. For the
NIGHT TIME time setting, specify your
normal sleep time (bedtime and wake-
up time).
Watch Operation Guide 3515
Configuring Sound and
Vibration Settings
In addition to button operation and notification
sounds and vibration, your watch also uses
sound and vibration for alerts. You can use the
procedure below to enable or disable sound
and vibration.
Note
The pattern and duration of the sound
●
or vibration cannot be changed.
Configuring Operation Sound and
Vibration Settings
1.
Display the current time screen.
Watch Mode
l
2.
Hold down (A) for at least two seconds.
This enters the Control Mode.
3.
Use (A) and (D) to select [SETTING].
4.
Press (C).
This displays the setting menu screen.
Pointer
5.
Use (A) and (D) to move the pointer to
[GENERAL SETTINGS].
6.
Press (C).
This displays the GENERAL SETTINGS
screen.
7.
Use (A) and (D) to move the pointer to
[BEEP/VIBE].
8.
Press (C).
9.
Use (A) and (D) to move the pointer to
[BUTTON OPERATION].
10.
Press (C).
11.
Use (A) and (D) to select operation sound
and vibration settings.
Operation sound on,
[BEEP+VIBE]
Operation vibration on
Operation sound on,
[BEEP]
Operation vibration off
Operation sound off,
[VIBE]
Operation vibration on
Operation sound off,
[OFF]
Operation vibration off
12.
Press (C) to complete the setting
operation.
After the setting operation is complete, a
check mark appears for a few seconds,
and then the sound and vibration setting
screen re-appears.
13.
Hold down (E) for at least one second to
return to the current time screen.
Note
If you do not perform any operation for
●
two or three minutes while the setting
screen is displayed, the watch
automatically returns to the current
time screen.
80
Advertisement
