Advertisement
Enabling Auto Lap Timing
While auto lap timing is enabled, a lap is
recorded each time you run the lap distance
you specified.
Perform the required operations with the
CASIO WATCHES phone app or on the watch
to configure auto lap measurement settings.
You can set a lap measurement distance up
to 10.0 km, in increments of 0.1 km.
To configure auto lap settings with the
●
CASIO WATCHES phone app
Before using Auto Lap Timing, you need to
use the CASIO WATCHES phone app to
specify the Auto Lap Timing distance.
Check the connection
Make sure the
symbol is shown on the
e
●
watch display when you perform the
procedure below. If
is not displayed,
e
refer to the information at the link below.
Connecting with a Phone Paired
l
With the Watch
1. Y
Tap the "CASIO WATCHES" icon.
2. Y
Tap the "My Watch" tab.
3. Y
Select "GBD-H2000" and tap it.
4. Y
Select the setting you want to change
and then perform the operation shown on
the screen.
Watch Operation Guide 3515
To configure auto lap settings with the
●
watch
1.
Display the current time screen.
Watch Mode
l
2.
Press (C).
This enters the Activity Mode.
Example:
3.
Use (A) and (D) to select an activity.
4.
Press (C).
For activities that can be measured
●
without receiving GPS signals, this
operation returns to the measurement
operation ready screen. In this case,
advance to step 6.
If you selected an activity that receives
●
GPS signals for measurement, this
operation starts the GPS signal receive
operation.
5.
If you selected an activity that receives
GPS signals for measurement, press (A)
or (D).
This displays the measurement operation
ready screen.
6.
Hold down (A) for at least two seconds.
This displays the activity measurement
setting screen.
Pointer
7.
Use (A) and (D) to move the pointer to
[AUTO LAP].
8.
Press (C).
9.
Use (A) and (D) to select [ON].
To disable auto lap measurement,
●
select [OFF].
The currently selected setting will be
●
indicated by a check mark (
left.
10.
Press (C).
This causes a cursor to appear, which you
can use to set the auto lap measurement
distance.
11.
Use (A) and (D) to specify the integer part
of the distance value.
12.
Press (C).
This moves the cursor to the decimal part
of the distance value.
13.
Use (A) and (D) to specify the decimal part
of the distance value.
14.
Press (C) to complete the setting
operation.
After the setting operation is complete, a
check mark appears for a few seconds,
and then the activity measurement setting
screen re-appears.
15.
Press (E) to exit the setting screen.
Note
If GPS is being used for Auto Lap
●
measurement, the Auto Lap
measurement timing may be
somewhat different from the distance
setting.
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
) to the
67
Advertisement
