Advertisement
Checking the Current
Altitude
1.
Display the current time screen.
Watch Mode
l
2.
Use (A) and (D) to select [ALTIMETER].
3.
Press (C).
This displays the altitude for your current
location.
Each press of (A) or (D) toggles
●
between the value display and graph
display.
Value Screen
①
②
Graph Screen
①
②
Current location altitude
A
Differential between reference
B
altitude and current altitude
Altitude graph
C
Current reading
Watch Operation Guide 3515
The watch takes altitude readings every
●
second for about the first three minutes.
After that, it takes readings according to
the watch's auto measurement interval
setting.
Check the information at the link below
●
to find out how to configure the auto
measurement interval.
l
To retrigger measurement, press (C).
●
To return to the current time screen,
●
hold down (E) for at least one second.
Note
Measurement range: -10,000 m to
●
10,000 m (-32,800 to 32,800 feet)
(Measurement unit: 1 meter (5 feet))
Note that calibrating altitude readings
will cause a change in the
measurement range.
[- - - - -] appears for the measured value
●
if it is outside the allowable range.
③
Setting the Auto Measurement
Interval
Setting a Reference Altitude
and Taking Altitude
Differential Readings
You can use the procedure below to display
the differential between a reference altitude
and another altitude. This makes it easy to
measure the altitude differential between two
points while climbing or trekking.
1.
Use the contour lines on your map to
determine the altitude differential between
your current location and your destination.
2.
Take an altitude reading of your current
location.
Checking the Current Altitude
l
3.
Hold down (A) for at least two seconds.
This displays the altitude measurement
setting screen.
Pointer
4.
Use (A) and (D) to move the pointer to
[DIFF RESET].
5.
Use (C) to set your current location's
altitude as the reference altitude.
After the setting operation is complete, a
check mark appears for a few seconds,
and then the altitude measurement
setting screen re-appears.
6.
Press (E).
This returns to the altitude measurement
screen.
44
Advertisement
