Measuring Your Blood
Oxygen Level
Important!
It may not be possible to obtain blood
●
oxygen level measurement results if
you are in a cold location and your wrist
is cold. Warm your wrist before
attempting measurement.
If measurement at the same location
●
on your wrist fails continuously or if
measured values fluctuate widely,
change the location on your wrist
where you are wearing the watch. You
can also try moving the watch to your
opposite wrist for measurement.
Take several measurements under
●
identical conditions, moving the watch
around your wrist. Find the wrist
location where measurement is most
stable.
Do not take measurements
●
immediately after exercising. Wait until
your breathing stabilizes.
During measurement, keep your arm
●
still and do not move it.
During measurement, refrain from
●
talking and do not hold your breath.
1.
While seated, place your arm on a table or
some other flat surface.
2.
Keep your elbow and wrist as unbent and
straight as possible.
Watch Operation Guide 3515
3.
Make sure the band is not contact with the
surface below your arm and not pressed
against your wrist.
4.
Display the current time screen.
Watch Mode
l
5.
Use (A) and (D) to select [BLOOD
OXYGEN].
6.
Press (C).
This displays the blood oxygen level
measurement screen.
7.
Press (C).
Start blood oxygen level measurement.
The measurement result is displayed after
a blood oxygen level measurement
operation is complete.
8.
Hold down (E) for at least one second to
return to the current time screen.
Note
The message [ERROR] appears on
●
the display if a blood oxygen level
measurement error occurs.
The message [- - -%] appears on the
●
display if the measured value is
outside the allowable measurement
range.
The watch automatically returns to the
●
current time screen if you do not
perform any operation for about one
hour while using the blood oxygen
level measurement function.
39