Advertisement
Configuring Training Alert
Settings
You can use the CASIO WATCHES phone
app to specify target alert intervals to inform
you of your calories burned, elapsed time,
distance traveled, and altitude climbed during
training. Every time an alert target value is
reached during activity measurement, a
sound or vibration operation is performed, and
an alert screen appears to notify you.
You can use a single watch operation to toggle
all the alerts you configured with the CASIO
WATCHES phone app between on and off.
To specify training alert target values
●
with the CASIO WATCHES phone app
Important!
Note that you cannot specify alert
●
target values using watch operations.
Use the CASIO WATCHES phone app
to configure settings.
Check the connection
Make sure the
symbol is shown on the
e
●
watch display when you perform the
procedure below. If
is not displayed,
e
refer to the information at the link below.
Connecting with a Phone Paired
l
With the Watch
1. Y
Tap the "CASIO WATCHES" icon.
2. Y
Tap the "My Watch" tab.
3. Y
Select "GBD-H2000" and tap it.
4. Y
Select the setting you want to change
and then perform the operation shown on
the screen.
Watch Operation Guide 3515
To enable training alert with the watch
●
1.
Display the current time screen.
Watch Mode
l
2.
Press (C).
This enters the Activity Mode.
Example:
3.
Use (A) and (D) to select an activity.
4.
Press (C).
For activities that can be measured
●
without receiving GPS signals, this
operation returns to the measurement
operation ready screen. In this case,
advance to step 6.
If you selected an activity that receives
●
GPS signals for measurement, this
operation displays the GPS signal
reception start screen.
5.
If you selected an activity that receives
GPS signals for measurement, press (A)
or (D).
This displays the measurement operation
ready screen.
6.
Hold down (A) for at least two seconds.
This displays the activity measurement
setting screen.
Pointer
7.
Use (A) and (D) to move the pointer to
[TRAINING ALERT].
8.
Press (C).
9.
Use (A) and (D) to move the pointer to
[ON].
If you want to disable training alerts,
●
move the pointer to [OFF].
10.
Press (C) to complete the setting
operation.
After the setting operation is complete, a
check mark appears for a few seconds,
and then the activity measurement setting
screen re-appears.
11.
Press (E) to exit the setting screen.
Important!
Use the CASIO WATCHES phone app
●
to specify an alert target value for each
item. You cannot use watch operations
to configure alert target value settings.
Note
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
70
Advertisement
