5.06
Power Supply Basic Parts Replacement
WARNING
Disconnect primary power to the system before disassembling the torch, leads, or power supply.
This section describes procedures for basic parts replacement. For more detailed parts replacement
procedures, refer to the Power Supply Service Manual.
A.
Filter Element Assembly Replacement
The Filter Element Assembly (9-0116) is in the rear panel. For better system performance, the filter ele-
ment should be checked per the Maintenance Schedule (Section 5.02), and either cleaned or replaced.
1.
Remove power from the power supply; turn OFF the gas supply and bleed down the system.
2.
Remove the clear filter bowl with wrench
NOTE!
Filter replacement part numbers can be found in Section 6 of this manual.
3.
Remove the filter element and clean or replace.
NOTE!
If replacing or cleaning just the filter element refer to the following illustration for disassembly.
4.
Install the new or cleaned assembly by reversing these procedures.
5.
Turn ON the air supply and check for leaks before reinstalling the cover.
0-5561
Regulator/Filter
Assembly
Art # A-13255
provided with the system 9-9675.
Filter Element
Art # A-07990
SERVICE
CUTMASTER 60i
59