ESAB THERMAL DINAMICS CUTMASTER 60i Operating Manual page 26

CUTMASTER 60i
Installing Optional Single - Stage Air Filter
An optional filter kit (7-7507) is recommended for improved filtering with compressed air, to keep
moisture and debris out of the torch.
1. Attach the Single - Stage Filter Hose to the Inlet Port 1/4" NPT of the system filter.
2. Attach the Filter Assembly to the filter hose.
3. Connect the air line to the Filter using the 1/4" NPT. The illustration shows typical fittings as
an example.
NOTE!
For a secure seal, apply thread sealant to the fitting threads, according to manufacturer's instructions.
Do not use Teflon tape as a thread sealer, as small particles of the tape may break off and block the
small air passages in the torch.
NOTE!
Filter replacement part numbers can be found in Section 6 of this manual.
Installing Optional Two - Stage Air Filter Kit
This optional two - stage air line filter (9-9387) is also for use on compressed air shop systems. Filter
removes moisture and contaminants to at least 5 microns.
Connect the air supply as follows:
1. Attach the Two Stage Filter bracket to the back of the power supply with the screws supplied.
NOTE!
For a secure seal, apply thread sealant to the fitting threads, according to manufacturer's instructions.
Do not use Teflon tape as a thread sealer, as small particles of the tape may break off and block the
small air passages in the torch.
2. Connect the two stage filter outlet hose to the inlet port of the Regulator / Filter Assembly.
26
Hose Clamp
Gas Supply
Hose
Optional Single - Stage Filter Installation
INSTALLATION
1/4 NPT
Inlet Port
System Filter
Assembly
Art # A-13261
0-5561