Section 3 Torch; Installation; 01 Torch Connections; 02 Setting Up Mechanical Torch - ESAB THERMAL DINAMICS CUTMASTER 60i Operating Manual

SECTION 3 TORCH:

INSTALLATION

3T.01 Torch Connections
If necessary, connect the torch to the Power Sup-
ply. Connect only the ESAB model SL60, SL60QD™
or SL100 / Mechanical Torch to this power supply.
Maximum torch leads length is 100 feet / 30.5 m,
including extensions.
WARNING
Disconnect primary power at the source before
connecting the torch.
1. Align the ATC male connector (on the
torch lead) with the female receptacle.
Push the male connector into the female
receptacle. The connectors should
push together with a small amount of
pressure.
2. Secure the connection by turning the
locking nut clockwise until it clicks.
DO NOT use the locking nut to pull the
connection together. Do not use tools
to secure the connection.
Art # A-13286_AB
Connecting the Torch to the Power Supply
3. The system is ready for operation.
Check Air Quality
To test the quality of air:
1. Put the ON / OFF switch in the ON (Left)
position.
0-5561
2
1
INSTALLATION
2. Select SET
3. Place a welding filter lens in front of the
torch and turn ON the air. Do not start
an arc! Any oil or moisture in the air will
be visible on the lens.
3T.02 Setting Up Mechanical Torch
WARNING
Disconnect primary power at the source before
disassembling the torch or torch leads.
The mechanical torch includes a positioning tube
with rack and pinch block assembly.
1. Mount the torch assembly on the cut-
ting table.
2. To obtain a clean vertical cut, use a
square to align the torch perpendicular
to the surface of the workpiece.
Workpiece
Mechanical Torch Set - Up
3. The proper torch parts (shield cup, tip,
start cartridge, and electrode) must be
installed for the type of operation. Refer
to Section "4T.01 Torch Parts Selection".
CUTMASTER 60i
mode.
Pinch Block
Assembly
Square
A-02585
29