Table of Contents
Advertisement
ESAB CuTmASTEr 100
5.06
Power Supply Basic Parts
Replacement
WARNING
Disconnect primary power to the system before
disassembling the torch, leads, or power supply.
This section describes procedures for basic parts
replacement. For more detailed parts replacement
procedures, refer to the Power Supply Service Manual.
A. Cover Removal
1. Remove the upper and lower screws which
secure the cover to the main assembly. Do
not loosen the lower screws inside the cut out
slots in the bottom of the cover.
Upper
Screws
Slots
Lower
Screws
Art # A-08429
2. Carefully pull the Cover up and away from the
unit.
B. Cover Installation
1. Reconnect the ground wire, if necessary.
2. Place the cover onto the power supply so that
slots in the bottom edges of the cover engage
the lower screws.
3. Tighten lower screws.
4. Reinstall and tighten the upper screws.
5-6
All manuals and user guides at all-guides.com
C. Filter Element Assembly Replacement
The Filter Element Assembly is in the rear panel. For
better system performance, the filter element should
be checked per the Maintenance Schedule (Section
5.02), and either cleaned or replaced.
1. Remove power from the power supply; turn
2. Remove the system cover. See "A Cover
3. Locate the internal air line and the fitting from
4. Hold a wrench or similar tool against the lock-
Lower
Screws
SERVICE
OFF the gas supply and bleed down the sys-
tem.
Removal" in this section.
the filter assembly. Number 1 in the following
illustration.
ing ring on the filter assembly fitting, then pull
on the hose to release it. (Numbers 2 and 3 in
the following illustration).
1
Art # A-07989
2
4
3
5
6mm
Manual 0-5404
Advertisement
Table of Contents
