Section 3 System: Installation; Unpacking; Lifting Options; Opening The Main Switch Cover - ESAB THERMAL DINAMICS CUTMASTER 60i Operating Manual

3.01

Unpacking

1. Use the packing lists to identify and account for each item.
2. Inspect each item for possible shipping damage. If damage is evident, contact your distributor
and / or shipping company before proceeding with the installation.
3. Record Power Supply and Torch model and serial numbers, purchase date and vendor name,
in the information block at the front of this manual.
3.02

Lifting Options

The Power Supply includes handles for hand lifting only. Be sure unit is lifted and transported safely
and securely.
WARNING
Do not touch live electrical parts.
Disconnect input power cord before moving unit.
FALLING EQUIPMENT can cause serious personal injury and can damage equipment.
HANDLES are not for mechanical lifting.
• Only persons of adequate physical strength should lift the unit.
• Lift unit by the handles, using two hands. Do not use straps for lifting.
• Use optional cart or similar device of adequate capacity to move unit.
• Place unit on a proper skid and secure in place before transporting with a fork lift or other
vehicle.
3.03

Opening the Main Switch Cover

Systems are configured for and come with power cord connected for single phase or three phase
configuration depending on system purchased. The input power switch is located on the rear panel
along the top. To access the input locations, remove the screw at the top of the cover and flip down.
WARNING
Disconnect power before removing the cover.
0-5561

SECTION 3 SYSTEM: INSTALLATION

Main Switch Cover
INSTALLATION
CUTMASTER 60i
23