ESAB THERMAL DINAMICS CUTMASTER 60i Operating Manual page 36

CUTMASTER 60i
Select Cutting Mode
1. Press and release the upper knob without turning to enter the mode selection menu. Place
the system in one of the four cutting modes available by pressing and releasing the knob
until you reach the desired mode.:
RUN
LATCH .
RAPID AUTO RESTART
GOUGE
SET/PURGE (gas flow only)
2. After selecting the cutting mode, set the output current by turning the knob.
Set Torch Parameters
1. Press and release the bottom knob without rotating to enter the torch type and leads length
selections.
Set Operating Pressure
NOTE!
Before the gas pressure is set, the torch type, leads length, type of cutting and amperage should all be set as they
will affect the pressures required. If any of those are changed, the pressure should be checked again to make sure it is
optimized.
1. Gas pressure must be set in the cutting mode to be used, not in the SET/PURGE mode. Each
mode may require a different pressure for optimal cutting. (90 - 125 PSI / 6.2 - 8.6 bar)
36
Art # A-13251
OPERATION
1
2
0-5561