Test Functions; Digital Output Test; Digital Input Test - Rice Lake LaserLight3 Series Technical Manual

LaserLight3 Remote Display
8.8

Test Functions

8.8.1

Digital Output Test

The Digital Output Test displays if a digital output is operational.
Figure 8-17 displays a menu path to the Digout parameter.
1. Navigate to Setup ► Test ▼ Digout.
2. Press . Bit 1 displays.
3. Press or
4. Press . The bit activates for three seconds, displays OK and then becomes inactive.
NOTE: Digital output bits must be configured as an output to be tested. "Bit not configured" displays if the test is activated
for a digital output bit that is not assigned. See
for digital I/O configuration description.
5. Press to exit the menu.
8.8.2

Digital Input Test

Perform the following to test Digital Inputs:
The Digital Input Test Displays a summed decimal representation of all active Digital I/O (J5 on the CPU board) input signals.
Figure 8-17 displays a menu path to the Digin parameter.
1. Navigate to Setup ► Test ▼ Digout ►... ►Digin.
2. Press . The summed values read from the digital input bits displays.
NOTE: The summed data range is 0 - 15. Each input bit provides a specific value:
3. Press to exit the menu.
86 Visit our website
Setup Mac ID
LightLvl
Figure 8-16. Digout parameter Menu Path
repeatedly until the desired Bit is selected.
Section 2.6.5 on page 18
Setup Mac ID
LightLvl
Figure 8-17. Digin parameter Menu Path
Connector Pin
J5 1 +5 VDC, 250 mA max
2 GND
3 DIO1
4 DIO2
5 DIO3
6 DIO4
Table 8-2. Digin Bit Range
www.RiceLake.com
Test Time
Digout
for pin assignments and
Test Time
Digout Digin
Signal Input Bit
-
-
1
2
4
8
Section 5.2.5 on page 63