Introduction; Safety - Rice Lake LaserLight3 Series Technical Manual

1.0

Introduction

This manual is intended for use by service technicians responsible for installing and servicing the LaserLight3 Remote Display.
Remote display configuration is detailed in
the Revolution configuration utility or the front panel keys. See
®
Manuals and additional resources are available from Rice Lake Weighing Systems at
Warranty information can be found at
1.1

Safety

Safety Definitions:
DANGER: Indicates an imminently hazardous situation that, if not avoided, will result in death or serious injury. Includes
hazards that are exposed when guards are removed.
WARNING: Indicates a potentially hazardous situation that, if not avoided, could result in serious injury or death. Includes
hazards that are exposed when guards are removed.
CAUTION: Indicates a potentially hazardous situation that, if not avoided, could result in minor or moderate injury.
IMPORTANT: Indicates information about procedures that, if not observed, could result in damage to equipment or
corruption to and loss of data.
Do not operate or work on this equipment unless this manual has been read and all instructions are understood.
Failure to follow the instructions or heed the warnings could result in injury or death. Contact any Rice Lake
Weighing Systems dealer for replacement manuals.
Some procedures described in this manual require work inside the indicator enclosure. These procedures are to be performed by
qualified service personnel only.
Do not allow minors (children) or inexperienced persons to operate the LaserLight3.
Do not place fingers into slots or possible pinch points.
Do not use any load-bearing component that is worn beyond 5% of the original dimension.
Do not use this product if any of the components are cracked.
Do not make alterations or modifications to the unit.
Do not remove or obstruct view of warning label
Before opening the unit, ensure the power cord is disconnected from the outlet.
Section 4.0 on page 36. Configuration of LaserLight3 can be accomplished using
Section 5.0 on page 53
www.ricelake.com/warranties
General Safety
WARNING
Failure to heed could result in serious injury or death.
(Figure 1-1).
WARNING!
HIGH VOLTAGE
DISCONNECT POWER BEFORE SERVICING
Figure 1-1. Safety Label (PN 16861)
for information about configuration.
© Rice Lake Weighing Systems ● All Rights Reserved
Introduction
www.ricelake.com/manuals
7