Table of Contents
Advertisement
3.9
Simultaneous Transmitter Mode
The Transmitter mode makes it possible to have simultaneous transmission of the values on each single channel via the serial
line. In addition, through the optional alibi memory board, the transmitted weight values can be stored in a computer for data
processing and/or integration. The filed values can then be recalled from the PC serial line or directly on the instrument's
display. See
Section 4.3.1 on page 19
of channels.
In this mode the zero tracking and the scale keys
Note
functioning modes and the Aibi mode is set automatically.
To set the Transmitter mode:
1. Power on the instrument and press
2. Press
to enter the menu.
3. Navigate until trAnSM displays. Press
4. Press
multiple times until SAVE? displays. Press
Operation
In the simultaneous Transmitter mode it is possible to view the weighing information. See
Reviewing Stored Weigh Information.
• Press
to switch channels, if the scale is configured as multichannel
• Only functions which can be enabled through serial commands can be performed; Not all serial commands can be
performed
(Section 6.3 on page
• The list of usable serial commands includes: PID, ALRD, ALDL, VER, REXT, REXTA, READ, MVOL, RAZF,
CGCHN, ECHO, DISP, DINT, PCOK, STAT, KEYP, KEYR, KEYEE, KEYED
Pressing simulation of the scale keys through the KEYP and KEYR commands allows for management of the
Note
functions linked to
3.10 Selecting Printing Functions
Use the following procedure below to set printing functions
1. Turn on the instrument and press
2. Press
to enter the menu.
3. Press
or
4. Press
or
• ZEro – Rearms print at zero; Only prints after rearming
• inSt – Rearms print when weight becomes stable
• ALWAyS – Prints when
5. Press
to confirm.
6. Slowly press
• Press
to confirm and store to the instrument memory
• Press any other key to cancel and exit without saving
for configuring type parameters and
while firmware version displays. tYPE displays.
to select.
42); It is not possible to carry out other operations in simultaneous Transmitter mode
.
while the firmware version displays. F.ModE displays.
until rEACT displays. Press
to scroll through the options.
is pressed, regardless of condition
multiple times until SAVE?displays.
Section 4.4 on page 22
,
and
are disabled. It is not possible to set
to confirm.
(Section 4.3.2 on page
19):
to enter the menu.
© Rice Lake Weighing Systems ● All Rights Reserved
Operation
for configuring the number
Section 3.11.2 on page 12
regarding
11
Advertisement
Table of Contents
