Reporting Commands; Reset Configuration Command - Rice Lake LaserLight3 Series Technical Manual

7.2

Reporting Commands

Reporting commands send specific information to the communications port. The commands listed in
either Setup mode, Weigh mode or Remote Display mode.
Command
DUMPALL Returns a list of all parameter values
DUMPAUDIT Returns the Audit Trail information
KDUMPAUDIT Returns the Audit Trail information on the same port which the EDP command was sent
AUDIT.LRVERSION Returns the legally relevant firmware version
AUDIT.CONFIG Returns the number of times configuration has changed
AUDITJUMPER Returns the position of the audit jumper: OK (if the audit jumper is ON) or ?? (if the audit jumper is OFF)
VERSION Returns the installed firmware version
BUILD Returns the firmware version and build number
HARDWARE Returns the option card installed
HWSUPPORT Returns the CPU board part number
RTCBATTERYSTATUS Returns the status of the real time clock battery: GOOD or BAD
TEST.TEMPSENSOR Enter command to view CPU board temperature in Celsius
7.3

Reset Configuration Command

The following command can be used to reset the configuration parameters of the LaserLight3.
Command
RESETCONFIGURATION
NOTE: All scale calibration settings are lost when the RESETCONFIGURATION command is run
Table 7-2. Reporting Commands
Restores all configuration parameters to default values (Setup mode only)
Table 7-3. Reset Configuration Command
© Rice Lake Weighing Systems ● All Rights Reserved
Function
Function
EDP Commands
Table 7-2 can be used in
.
71