Care; Removing The Shade; Cleaning Procedures - HunterDouglas Vignette Modern Roman Shades Installation Operation Care

CARE

Removing the Shade

Fully raise both the front shade and back panel.
■
While holding the headrail, place the
■
blade of a small screwdriver on the
installation bracket's locking tab.
Insert the screwdriver between the
➤
arrows on the bottom tabs.
CAUTION: Be very careful not to tear
or damage the fabric.
Push up to release the shade.
■
IMPORTANT: On longer shades, you
might need to lower the front shade
slightly to access the locking tab.

Cleaning Procedures

Hunter Douglas Vignette
fabrics that repel dirt and dust. For most fabrics, the following cleaning options are available.
Dusting
Regular light dusting with a feather duster is all the cleaning needed in most circumstances.
■
Vacuuming
Use a hand-held vacuum with low suction for more thorough dust removal.
■
Compressed Air/Hair Dryer (Cool Setting)
Blow dirt and debris from within the fabric folds using clean, compressed air.
■
Spot-Cleaning
Spot clean using a sponge or delicate cloth, warm distilled water, and a mild soap
■
solution. Handle with care as you would any fine fabric.
Dab the spot with the dampened sponge or cloth until it is removed. Rubbing alcohol or
■
non-oil-based baby wipes may be used on more stubborn stains. Do not rub the fabric.
Allow the shade to dry in the completely lowered position.
■
Cleaning the Back Panel
The back panel fabric can be cleaned by dusting, low suction hand-held vacuuming,
■
compressed air, hair dryer on the cool setting, or the dry method of injection/extraction.
28
Modern Roman Shades are made with anti-static, dust-resistant
®
Push
Up
Locking
Tab
Arrows