INSTALLATION
Mount the Installation Brackets — Inside Mount
Measure and mark 3" in from each jamb (two bracket widths) for bracket location.
■
If more than two installation brackets came with your order, space additional bracket(s)
➤
evenly between the two end brackets and mark the location. Mount into wood
whenever possible. Allow a minimum of 18" between bracket center lines
(motor side) for the battery wand/rechargeable battery wand.
3"
Jamb
Recommended Best Practice: To enhance ease of installation, position the front edge of
the installation bracket approximately
Center the brackets on your marks, then mark the screw hole locations.
■
The minimum casement depth for installation
➤
brackets is 1" (1
headrail-mounted rechargeable battery wand).
Mark the rear set of installation bracket
holes with shallow mounting depths.
The minimum casement depth for a fully
➤
recessed mount is 4" (4
headrail-mounted rechargeable battery wand).
Mark the front set of bracket holes when
depth permits.
IMPORTANT: For shades with a battery wand and
rechargeable battery wand, allow a minimum of
clearance behind the brackets to accommodate the wand.
Predrill the screw holes using a
■
CAUTION: Use drywall anchors when mounting into drywall.
Use a level to check that the mounting surface is
■
level. Shim (not provided) the brackets if necessary.
Using a 1/4" hex, attach the installation brackets
■
using the screws provided.
IMPORTANT: The front edges of the installation
brackets must align to each other. For the best
experience, mount the brackets with the front lip
outside the window casement.
Proceed to "STEP 2 — Remove the Shipping Clips" on page 7.
4
Space Evenly
Window Opening
⁄
" into the room.
1
4
⁄
" with battery wand or
3
8
⁄
" with battery wand or
1
2
⁄
" drill bit.
3
32
3"
Space Evenly
⁄
"
3
4
Minimum
Casement
Depth 1"
Minimum
1
⁄
" with
3
8
Battery Wand
3"
Jamb
3"
Minimum
Casement
Depth 1"
Minimum
1
⁄
" with
3
8
Battery Wand