Mount The Installation Brackets - Outside Mount - HunterDouglas Vignette Modern Roman Shades Installation Operation Care

Mount the Installation Brackets — Outside Mount
Center the headrail over the window opening at the desired height. Use a pencil to lightly
■
mark each end of the headrail.
Alternatively, measure the width of the headrail and use that width to mark the
➤
headrail end points over the window opening.
Measure and mark 3" from each end of the headrail.
■
If more than two installation brackets came with your order, space additional bracket(s)
➤
evenly between the two end brackets and mark the location. Mount into wood
whenever possible. Allow a minimum of 18" between bracket center lines
(motor side) for the battery wand/rechargeable battery wand.
3"
Headrail End Mark
Center the brackets on your marks, then mark the screw hole locations.
■
A minimum 1" flat vertical surface is required.
➤
The top of the installation brackets should be
➤
at the desired height. The brackets must be
level and aligned.
CAUTION: The rear of the brackets must be flush
against a flat mounting surface. Do not mount
brackets on curved molding.
Predrill the screw holes using a
■
CAUTION: Use drywall anchors when mounting
into drywall.
Space Evenly
Window Opening
⁄ " drill bit.
3
32
INSTALLATION
Space Evenly
Headrail End Mark
3"
3"
5