INSTALLATION
STEP 3 — Install the Shade
Headrail Attached Battery Wands (If Applicable)
NOTE: Refer to this section only if you have a battery wand that attaches to the headrail.
Attach each battery wand clip to the rear headrail, avoiding the installation brackets.
■
NOTE: The battery wand clips can simply slide clear of the installation brackets.
Step 1: Hook the battery wand clip onto the back channel of the headrail.
➤
Step 2: Rotate the clip down until it snaps into place.
➤
Battery Wand
Battery
1
Wand Clip
2
CAUTION: Be sure the power cable does not become pinched by the brackets or headrail
during installation; damage or overheating of components could result.
CAUTION: Do not connect the battery wand to the power cable prior to installing
the shade.
Rechargeable Battery Wand (If Applicable)
NOTE: Refer to this section only if you
have a rechargable battery wand.
Align the battery mount with the
■
battery clips, orienting the socket
end towards the right of the shade.
Push the battery mount straight
■
into the battery wand clips until it
snaps into place. Check to make
sure the battery mount is secure.
Plug the power cable into the battery mount.
■
8
Hook onto
Back Channel
Front of
Headrail
Snap Clip
into Place
Rechargeable Battery Wand
Rechargeable
Battery Wand
Clip
Socket
Back of Shade
Hook onto
1
Back Channel
Front of
Headrail
Snap Clip
2
into Place
Socket