HunterDouglas Vignette Modern Roman Shades Installation Operation Care page 29

Problem
The shade raises or lowers unevenly, the bottom rail is not level when fully
raised, or the fabric winds unevenly or starts to rub against one end of the
headrail.
Solution
Check if the window is out-of-square by measuring the diagonals.
Check that the installation brackets are level. Shim (not provided) to level,
if necessary.
If the headrail is level and the window is square, adjust the bottom rail
weight.
Adjusting the Bottom Rail Weight
To adjust, access the bottom
rail weight from the back of
the front shade.
Push up on the weight clips
to release.
Slide the weight in 1" increments, toward the side where the fabric is
gathering.
Test the shade. Lower the front shade all the way and check that the bottom
rail is level. Adjust the weight until the fabric winds evenly and does not
gather on either side.
After final adjustments, slide the weight clips back into place.
Apply Skew Adjustment Tape to the Rear Roller Shade
Using the tape strips and instruction guide in the Skew Adjustment Kit
included with your order, place the tape strips onto the window side of the rear
roller shade fabric. The number of tape strips and their placement depends on
the type and severity of the skew, as explained in the instruction guide.
Problem
The shade limits need to be adjusted – top limit.
Solution
See "Electronic Limit Adjustments" on page 20.
Problem
The shade limits need to be adjusted – bottom limit.
Solution See "Electronic Limit Adjustments" on page 20.
Move Weight to Adjust
Weight
Clip
Tape
Strips
TROUBLESHOOTING
Weight Weight
Clip
27