Table of Contents
Advertisement
Presets and System setup
Configuration of the Measurement
menu
There are many more measurements and parameters in the
measurement package than shown in the default Measurement
menu. Use the configuration system to set up the
measurements that should be available in the Measurement
menu and which parameters should be calculated (see also
"Measurement package configuration" on page 134).
Display of the Measurement categories
1.
Press M&A categories in the Configuration window.
The M&A categories are displayed in a pop-up window
(see page 298).
2.
Check the categories to be displayed.
Uncheck the categories to hide.
To copy a Measurement category
1.
Press M&A categories in the Configuration window.
The M&A categories are displayed in a pop-up window
(see page 298).
2.
Move the trackball marker over the M&A category name.
3.
Press
4.
Press Create copy.
A copy of the selected measurement category is displayed
in the Measurement menu.
Factory Measure-
To rename the Measurement category:
ment categories
1.
Select the Measurement category in the Measurement
cannot be renamed.
menu.
2.
Enter a new name in the Measurement field.
Selection of a Measurement category
1.
Trackball to the Measurement menu heading.
2.
Press
The measurement categories are displayed in a
sub-menu.
3.
Trackball to the measurement category of interest.
4.
Press
The measurement category is displayed.
300
to highlight the category.
SET
.
SET
.
SET
Vivid i User's Manual
2378958-100 Rev. 02
Advertisement
Table of Contents
