Table of Contents
Advertisement
Measurement and Analysis
Entering a study and performing
measurements
Note: When enter-
1.
ing the Measure-
ment mode for the
first time, the Cali-
per tool is selected
by default.
When re-entering
2.
the Measurement
mode, the first mea-
3.
surement in the ac-
tual study that has
not been performed
4.
is selected by de-
fault.
To perform a measurement from another study
1.
2.
3.
4.
5.
To skip a measurement in a study
1.
2.
112
Press
on the front panel to enter the Assign and
MEASURE
Measure modality.
The Measurement menu with a list of studies is displayed
in the Parameters window (see example Figure 6-2).
Select any required study (other than Generic study which
is reserved for the Measure and Assign modality).
Within the selected study, select the required parameter
which you intend to measure.
Perform the measurement. The parameter's name and
measured value will appear in the result window.
Trackball to the required study.
Press
on the trackball area.
SET
The study folder is opened displaying the measurements
related to this study. Other related studies may also be
available from within the study.
Trackball to the measurement to perform.
Press
on the trackball area to activate the
SET
measurement tool.
The cursor is moved back to the scanning window.
Perform the measurement.
Completed measurements are marked with a check mark
(Figure 6-2).
When the measurement operation is completed the next
measurement on the list is automatically selected.
Trackball to the desired measurement
Press
to activate the measurement tool.
SET
Vivid i User's Manual
2378958-100 Rev. 02
Advertisement
Table of Contents
