Cardiac Measurements; 2D Measurements - GE Vivid i User Manual

Figure 6-5: The Enter new parameter window
4. Type a name for the parameter label.
5. Press OK.
The user defined parameter label is assigned to the
selected measurement.

Cardiac measurements

2D Measurements

2D Length measurements
1. Generate the 2D image.
2. Press
3. Press
4. Select Caliper in the Measurement Menu (see Figure 6-1).
5. Trackball the cursor to the start point of the measurement.
6. Press
See the Status bar
7. Trackball the cursor to the measurement end point.
to get the next step
The current distance value is displayed in the
to perform.
Measurement result table and is instantaneously updated
when moving the cursor.
The measurement 8. Press
display color on the
The measurement result is displayed in the Measurement
2D image changes
result table.
from green to red af-
9. To assign a label to the measurement, see page 115.
ter completion of
the measurement.
10. Repeat steps 5 through 8 to make additional length
measurements.
Vivid i User's Manual
2378958-100 Rev. 02
Measurement and Analysis
to stop the cineloop.
FREEZE
on the Control Panel.
MEASURE
to anchor the start point of the measurement.
SET
to anchor the end point of the measurement.
SET
117