Selecting A Probe And An Application - GE Vivid i User Manual

Getting started
Connectivity on the Vivid i ultrasound unit
Refer to page 186
The connectivity on the Vivid i Ultrasound unit is based on the
for further informa-
Dataflow concept. A Dataflow is a set of pre-configured
tion on connectivity
services (e.g. DICOM services like storage, worklist, verify etc.
setup.
or other service types like video print, standard print or
messaging). When starting an examination, the user selects a
pre-configured Dataflow that will automatically customize the
ultrasound unit to work according to the services associated to
the Dataflow.

Selecting a Probe and an Application

The combination
Probes and their related applications are selected from the
Probe-Application
Probes and applications pop-up menus as described below.
may be user-de-
Only probes currently connected are displayed in the pop-up
fined. See page 291
menu. Only applications appropriate for the type of probe
for information on
selected are shown.
probe/application
configuration.
To select a probe and an application
1.
2.
3.
4.
To select a probe 5.
with the default ap-
plication, press
SET
twice on the actual
probe.
Make sure that the probe and application names displayed on the
screen correspond to the actual probe and application selection.
CAUTION
Check that the correct TI category is displayed (see Chapter 14,
"Thermal Index" on page 353). TIB must be displayed when a
fetal application is selected.
46
Press
APPLICATION
A list of the connected probes is displayed.
Trackball to the desired probe.
Press .
SET
An Application menu for the selected probe is displayed.
Trackball to the desired application.
Press to launch the application.
SET
on the control panel.
2378958-100 Rev. 02
Vivid i User's Manual