Configuration Of The Measurement Menu - GE Vivid S5 User Manual

Configuration of the Measurement
menu
There are many more measurements and parameters in the
measurement package than shown in the default Measurement
menu. Use the configuration system to set up the
measurements that should be available in the Measurement
menu and which parameters should be calculated (see also
"Measurement package configuration" on page 338).
Display of the Measurement categories
1.
2.
To copy a Measurement category
1.
2.
3.
4.
To rename the Measurement category:
Factory Measure-
ment categories
1.
cannot be renamed.
2.
Selection of a Measurement category
1.
2.
3.
4.
Vivid S5/Vivid S6 User Manual
R2424458-100 Rev. 2
Press M&A categories in the Configuration window.
The M&A categories are displayed in a pop-up window
(see page 599).
Check the categories to be displayed.
Uncheck the categories to hide.
Press M&A categories in the Configuration window.
The M&A categories are displayed in a pop-up window
(see page 599).
Move the trackball marker over the M&A category name.
Press to highlight the category.
SET
Press Create copy.
A copy of the selected measurement category is displayed
in the Measurement menu.
Select the Measurement category in the Measurement
menu.
Enter a new name in the Measurement field.
Trackball to the Measurement menu heading.
Press .
SET
The measurement categories are displayed in a
sub-menu.
Trackball to the measurement category of interest.
Press .
SET
The measurement category is displayed.
Presets and System setup
601