Table of Contents
Advertisement
Scanner's TCP/IP settings
To be able to use the network functions when connected to a
hospital network, the scanner must have a proper network
address. Typically source for this information in the network
administrator.
1.
2.
1. Computer name: device's name of type
VIVID7-00nnnn or ECHOPAC7-00nnnn, where
"nnnn" is the system's serial number. Do not
change the computer name.
2. IP settings: system IP settings
Figure 8-31: TCP/IP setting
3.
Vivid i User's Manual
2378958-100 Rev. 02
Press
and log on as administrator.
CONFIG
Select the Connectivity category and TCP/IP subgroup.
The TCPIP subgroup is displayed.
3. Remote archive setup: remote archive IP
4. Save TCP/IP settings. The changes will be
In the IP settings area enter:
• The IP address for the scanner
• The subnet mask for the scanner
• The IP address for the Default Gateway
address and name (EchoPAC PC or
EchoServer)
effective after the system is rebooted.
Archiving
193
Advertisement
Table of Contents
