Disconnecting A Fiber-Optic Cable From An Acx5000 Router - Juniper ACX5048 Hardware Manual

Figure 46: Installing a QSFP+ Transceiver—Horizontal Orientation

Disconnecting a Fiber-Optic Cable from an ACX5000 Router

The ACX routers has field-replaceable unit (FRU) optical transceivers to which you can connect fiber-optic
cables.
Before you disconnect a fiber-optic cable from an optical transceiver installed in an ACX router, ensure
that you have taken the necessary precautions for safe handling of lasers (see
Guidelines and Warnings for the ACX5000 Router" on page
Ensure that you have the following parts and tools available:
Rubber safety cap to cover the transceiver
Rubber safety cap to cover the fiber-optic cable connector
To disconnect a fiber-optic cable from an optical transceiver installed in an ACX5000 router:
1. (Recommended) Disable the port in which the transceiver is installed by including the disable statement
at the [edit interfaces] hierarchy level for the specific interface.
WARNING:
fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected to
transceivers emit laser light that can damage your eyes.
WARNING:
instruments even if the interface has been disabled.
2. Carefully unplug the fiber-optic cable connector from the transceiver.
Do not look directly into a fiber-optic transceiver or into the ends of
Do not stare into the laser beam or view it directly with optical
"Laser and LED Safety
178).
130