Table of Contents
Advertisement
GO-5000M-PMCL-UV User Manual (Ver. 1.1)
If the trigger is used, it uses "Frame Start".
The procedure is;
1. Select "Frame Start" in "Trigger Selector"
Note: In the GO-5000M-PMCL-UV, only "Frame Start" is available.
2. Select "Timed" or "Trigger Width" in "Exposure Mode".
3. Set "ON" in "Trigger Mode".
Caution:
For trigger operation, Exposure Mode must first be set to something other than OFF and
then Trigger Mode of Frame Start must be ON. If the exposure mode is set to OFF, the trigger
mode cannot be set.
Operational mode by the combination of the exposure mode and the trigger control.
Exposure Mode Setting Frame Start Trigger mode (ON/OFF)
OFF
Timed (ESP, RCT)
Trigger Width
Frame Start Trigger: The start of image capturing of a frame is controlled by the external
l
trigger.
Trigger Mode ON: Start the exposure by the selected signal for the frame start
l
Trigger OFF: The camera is in free-running mode
l
ExposureTime
This command is effective only when Exposure Mode is set to Timed. It is for setting exposure time.
The setting step for exposure time is 1 μsec per step.
Minimum: 10 μsec
l
Maximum: 8 seconds (Note – noise may make image unusable after 1 second)
l
OFF
OFF or ON
OFF
ON
Trigger Control
Not available
Preset exposure time
Not available
The pulse width of the input trigger pulse
- 71 -
Main Functions
Exposure Control
Advertisement
Table of Contents
