Table of Contents
Advertisement
GO-5000M-PMCL-UV User Manual (Ver. 1.1)
3. If you use 80-bit (8-tap/10-bit) camera configuration, DVAL and Exposure Active (JAI
custom) are not output through the Camera Link interface. FVAL is only output via Digital
I/O-1 connector.
Camera Link pixel clock frequency
In the GO-5000M-PMCL-UV, the Camera Link pixel clock can be selected from 84.99 MHz, 72.85
MHz, 58.28 MHz, and 48.57 MHz. If the 48.57MHz clock is used, the transfer length through the
camera link cable will be extended to 10m for all tap geometries. On the other hand, the frame rate will
be reduced (see table). The default setting is 72.85 MHz.
Camera Link
Pixel Clock
High (84.99 MHz)
Mid (72.85 MHz)
High (72.85 MHz)
Mid (58.28 MHz)
Low (48.57 MHz)
Note: The maximum lengths shown in the above table are guidelines. Operating at these lengths
may generate bit noise, depending on the cable used.
1X2-1Y
Maximum
Length
8 / 10 / 12bit
5m
31.9
5m
27.4
10m
-
10m
-
10m
18.3
1X3-1Y
1X4-1Y
8bit
8 / 10 / 12bit
47.8
63.6
41.0
54.7
-
-
-
-
27.4
36.4
- 28 -
Main Functions
1X8-1Y
8bit
10bit
-
-
-
-
107.2
-
-
84.9
70.8
70.8
Advertisement
Table of Contents
